LED Bar Graph

/*

LED bar graph

Turns on a series of LEDs based on the value of an analog sensor.

This is a simple way to make a bar graph display. Though this graph

uses 10 LEDs, you can use any number by changing the LED count

and the pins in the array.

This method can be used to control any series of digital outputs that

depends on an analog input.

The circuit:

* LEDs from pins 2 through 9 to ground

created 4 Sep 2010

by Tom Igoe

**************************************

**************************************

Experiment performed by:

Sulav Timsina(sulav7155@yahoo.com)

Sudip Shrestha(shrestha.sp11@gmail.com)

**************************************

**************************************

This example code is in the public domain.

http://www.arduino.cc/en/Tutorial/BarGraph

*/

// these constants won't change:

const int analogPin = A0; // the pin that the potentiometer is attached to

const int ledCount = 10; // the number of LEDs in the bar graph

int ledPins[] = {

2, 3, 4, 5, 6, 7,8,9 }; // an array of pin numbers to which LEDs are attached

void setup() {

// loop over the pin array and set them all to output:

for (int thisLed = 0; thisLed < ledCount; thisLed++) {

pinMode(ledPins[thisLed], OUTPUT);

}

}

void loop() {

// read the potentiometer:

int sensorReading = analogRead(analogPin);

// map the result to a range from 0 to the number of LEDs:

int ledLevel = map(sensorReading, 0, 1023, 0, ledCount);

// loop over the LED array:

for (int thisLed = 0; thisLed < ledCount; thisLed++) {

// if the array element's index is less than ledLevel,

// turn the pin for this element on:

if (thisLed < ledLevel) {

digitalWrite(ledPins[thisLed], HIGH);

}

// turn off all pins higher than the ledLevel:

else {

digitalWrite(ledPins[thisLed], LOW);

}

}

}